- 1
INDEX
1. Specifications
2. Dimension
3. Installation and connection
4. Accessories
5. Electrical wiring
6. Display controller operation
7. Running data setting
8. Troubleshooting
9. Exploded diagram
10. Maintenance
Thank you for purchasing our product for your pool or spa heating. Heat Pumps use the ambient air
temperature to heat your pool or spa water efficiently. Heat Pumps perform better with warmer ambient
temperatures & it will heat your water and maintain constant temperature whilst the ambient air
temperature is between -5 to 43℃. The use of a heat pump will extend your swimming season & provide
extra enjoyment for you and your family.
ATTENTION: This manual includes all the necessary information regarding the use and the
installation of your heat pump.
The installer must read the manual and attentively follow the instructions in implementation and
maintenance.
The installer is responsible for the installation of the product and should follow all the instructions of the
manufacturer and the regulations in application. Incorrect installation against the manual implies the
exclusion of the entire guarantee and warranty.
The manufacturer declines any responsibility for the damage caused to people, objects and errors due to
incorrect installation. It is the owners responsibility to ensure that the pool or spa water maintains correct
water chemistry balance as bad water chemistry can damage the heat pump internal components which
will not be covered under this warranty. Any usage outside of what is stated within this manual or its
designed purpose of manufacturing will be regarded as dangerous and is not recommended.
WARNING: Please always shut off the power supply if you need to open the heat pump cabinet to work
inside the heat pump. As this is an electrical product there is high voltage electricity inside. Any electrical
connections and/or repairs should be conducted by a licensed electrician.
WARNING: When using the 10mtr external control panel extension please ensure the display controller is
located in a dry area. Also keep the insulation cover closed to protect the display on the controller from
being damaged by humidity and possible rain.
WARNING: The heat pump must be stored and transported vertically in the original packaging.
If this is not the case, it cannot be operated immediately. A minimum time of 24 hours is required before
power on.
To Next Page
Loading...