EasyManua.ls Logo

muvit io ENC - Voice Assistant Activation; Charging and Pairing; Charging Function; Pairing and Synchronization

muvit io ENC
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
English
Press the right earphone once to increase the volume.
Answer a call / end a call
When an incoming call occurs:
Press the left or right earphone to answer a call.
Press again the left or right earphone to end a call.
Reject a call
When an incoming call occurs:
Press and hold the left or right earphone for 2 seconds
to reject the call.
Voice assistants
Quickly press the left or right earphone 3 times to
activate the voice assistant.
Charging function
Fully charge the case and earphones before using them
for the first time.
Do not use an adapter of more than 5V to charge this
item.
PAIRING
1. Automatic pairing.
The first time they are connected by removing the
earphones from the charging case, the earphones will
automatically turn on, sync and enter pairing mode.
To reset the earphones and put them into pairing mode,
you need to remove them from the charging case, click 5
times on both earphones at the same time and put them
back in the case; then close and open the lid, remove the
earphones and they are ready to be paired again.
2. Synchronization of the earphones.
When the earphones do not synchronize with each other
or go into a disconnected state during use:
Turn both earphones o and then on again.