This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee
that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
FCC Disclaimer:
This device Complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1– This device may not cause harmful interference, and
2– This device must accept any interference received,
including Interference that may ca
use undesired
operation. The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could
void the user authority to operate the equipment.
1– This device may not cause harmful interference, and
2– This device must accept any interference received, including
interference that may cause undesired operation. The
manufacturer is not responsible for any
radio or TV
interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's
authority to operate the equipment. Under Industry Canada
regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for
This device complies with Part 15 of the FCC Rules and Industry
Canada license-exempt RS5 standard(s). Operation is subject to the
following two condi
tions;
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or on experienced radio/TV technician
for help or assistance.
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain
should be so chosen that the equivalent is
otropically radiated
power (e.i.r.p.) is not more than that necessary for
successful communication.
Electronic and electrical devices disposal
This symbol indicates that electrical and electronic device is to be
collected separately.
This product is designated for separate collection at an
appropriate collection point. Do not dispose of as
household waste.
If the device use batteries, they must be removed from the
device and disposed in a appropriate collection center.
If the batteries cannot be removed, do not attempt to do it
yourself since it must be done by a qualified professional.
Separate collection and recycling helps conserve natural
resources and prevent negative consequence for human health
and the environment that might result from incorrect disposal.
Warning: To prevent possible hearing damage, do not listen at high volume levels for long periods.
P ARA M E T E R S
Bluetooth version: 5.0
Frequency:
2402
- 2480MHz
Battery
capacity:
30mAh
each
Total
playtime*: 3
– 4
hours
Total
standby
time:
50
hours
Bluetooth
range:
Up
to
30
ft
C H A R G I N G C A S E
Battery capacity: 300mAh
Charging time: 2 hours
Type-C USB charging
*Depen ds on individual use
W I T H C H A R G I N G C A S
T W S E A R B U D S
E
I N S T R U C T I O N M A N U A L: EBT-4-21175
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
To Next Page
Loading...
