Why does my MW POWER Inverter not turn on immediately after being turned off?
The MW POWER Inverter has a normal self-protection feature. If you turn it on immediately after turning it off, or after changing the mode during operation, you need to wait approximately 3 minutes for it to start.
Why is my MW POWER Air Conditioner not blowing enough air, or is too hot or cold?
There might be several reasons why your MW POWER Air Conditioner isn't providing sufficient airflow or the desired temperature. Here are some possible causes: * The temperature setting might be incorrect, so adjust it accordingly. * The air inlet or outlet of the indoor or outdoor unit could be blocked; clear any obstructions. * The air filter may be blocked; clean or replace it. * The fan speed might be set too low; increase the fan speed. * There might be other heat sources in the room; reduce them. * The refrigerant level could be low; check and refill if necessary.
Why does my MW POWER Air Conditioner not respond to the remote?
If your MW POWER Air Conditioner is not responding to the remote control, it could be due to these reasons: * The remote control might not be close enough to the indoor unit; move closer. * The remote control's batteries may be low; replace them. * There might be an obstacle between the remote control and the signal receiver on the main unit; remove any obstacles.
Why does my MW POWER Air Conditioner have a strange smell?
If your MW POWER Air Conditioner has a strange smell, the air filter is likely dirty. Clean or replace the air filter to resolve this issue.
Why does my MW POWER Air Conditioner display turn off?
The display of your MW POWER Air Conditioner might be off because: * The LED function is active; check if the LED function can be turned off. * There is no power; check the power supply.
Why does my MW POWER Air Conditioner make a sound of flowing water?
If you hear the sound of flowing water in your MW POWER Air Conditioner, it is likely due to regression liquid in the drain. Check and clear the drain to resolve this.
Why does my MW POWER Air Conditioner emit a slight mist?
This can happen when the air becomes very cold, for example, in COOL or DRY modes.
Covers essential safety guidelines for installation and usage of the air conditioner.
Lists crucial recommendations to avoid appliance damage and ensure safe operation.
Describes the auto-restart feature and how to activate/deactivate it.
Explains how to operate the unit using the emergency button when the remote fails.
Details the function of each button on the remote controller.
Explains the meaning of various symbols displayed on the remote controller.
Lists common faults, their possible causes, and solutions for the air conditioner.
To Next Page
General