IMPORTANT: Turn the Temperature control knob anticlockwise until the valve is
fully open before switching on the unit. This will ensure a fast fill up of the unit
when the shower is first switched on.
IMPORTANT: The shower unit must be full of water before heat settings are
used.
WARNING: If re-starting the shower immediately after stopping, be aware that a
slug of hot water will be expelled for the first few seconds.
ATTENTION: Do not operate the shower unit if the showerhead or hose
becomes damaged. The shower is designed and approved to EN-60335 with
the showerhead provided. Under no circumstances must any showerhead that
is not approved by the manufacturer be used with this product.
IMPORTANT: The shower spray head and shower filter MUST be cleaned
regularly to remove scale and debris. The frequency of cleaning will vary
according to local water quality. If the water becomes hot and you are unable to
obtain cooler water, immediately check the showerhead and filter for blockage.
See section 12 for comprehensive cleaning advice.
1. PLEASE READ THIS IMPORTANT SAFETY INFORMATION (CONT.)
IMPORTANT: This appliance is not intended for use by persons (Including children)
with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
DEFAULT PLUMBING SETTING: The shower unit is supplied for right hand
installation. To plumb the unit on the left you must remove the blanking cap and
refit it to the inlet pipe on the right hand side of the unit ensuring the metal fixing
clip is pushed firmly into the groove. When leak testing the installation you must
ensure there are no leaks from this area.
IMPORTANT: To comply with water regulations, building regulations or any
specific local water company regulations and should be in accordance with
BS EN 806. A double check valve must be fitted with all flexible shower
accessories where it is possible that the showerhead may come into contact
with used water i.e. In the bath or shower tray.
IMPORTANT: Before turning on the water supply to the shower unit the water
supply pipe should be flushed out to remove debris. After flushing the pipework
ensure that the shower unit is positioned squarely on the wall and tighten the
screws. Tighten all plumbing connections and check the pipework for leaks.
IMPORTANT: Ensure that the terminal block screws are fully tightened and that
no cable insulation is trapped under screws. Ensure the cable clamp is used to
secure the cable. The earth continuity conductor of the electrical installation must
be effectively bonded to earth on the fuse board.
CAUTION: Check there are no hidden cables or pipes before drilling holes for
wall plugs. Exercise great care when using power tools near water. The use of a
residual current device (RCD) is recommended.
To Next Page
Loading...