The MPC150 indoor pet barrier keeps your pet away from a certain room, away from trash,
off of furniture etc.… just Place the barrier transmitter near the area your pet should avoid.
The Barrier Transmitter creates a circular radio signal hidden fence adjustable from approx
1-8 ft in Radius. When your Pet enters the Hidden fence area, the collar will sound warning
tone first and then Depending on the mode the collar is set to will either provide safe static
corrections via the contact points on the collar or tone only to train and keep your pet away
from the desired area.
If you don’t want to change the collar’s pairing Channel when turning on, always switch on the
collar at least 15 FT away from the TX Box etc.…
Collar Modes (Dual Function): - The collar has a dual function, Mode.
To toggle/Change from either mode, short press the on/off button each time
Mode 1： (Tone + Static correction): - When Collar is on and is in Mode 1 the LED will
Blink once every 5 seconds
Mode 2: (Tone only): - When Collar is ON and is in Mode 2, LED will blink twice every
five seconds.
Charging The Collar: -Charge the collar by removing the circular Screw and use the Charging
Cable provided and connect to any Standard USB power port (5VDC) such as wall adapter,
cell phone Charger, PC USB Port Etc.… always allow approx. 3-4 Hours continuous charge
of the collar and ignore any of the charging light indicators when charging the collar. Please
note when plugging in the collar to charge, the collar will always turn to the OFF Position
automatically even if the collar is on before plugging in the charging cable. After charging the
collar fully, remove the Charging cord and screw back the cover and turn the collar on by long
pressing and holding down the on/off button for 2-3 seconds. When you see solid or Flashing
LED Light on the collar, the collar is in the ON Position
Turning Collar ON/OFF: - To turn the collar ON or OFF Press down on the ON/OFF button
for 2-3 seconds (Long Hold). One Beep turns the collar ON. And when you Hear 2 Beeps, the
collar turns OFF.
Please Note whenever the collar is Turned ON within 5 Feet of the Barrier Transmitter box
when Barrier TX Box is ON, the collar will be Matched to MODE A or MODE B or MODEA/B
depending on the switch position on the barrier box. Refer to Section “Programming the mode
settings” further in the manual for more info.
To Next Page
Loading...