Need help?Do you have a question about the My Pet Command DF113R and is the answer not in the manual?
Adjusts the boundary width, combining warning and correction zones.
Connects boundary wire to the transmitter to form a continuous loop.
Indicates if the system is on or off and functioning properly.
Shows if the boundary wire is forming a complete and continuous loop.
Explains the function of each button on the remote transmitter for operation.
Indicates status, low battery, and charging status of the receiver collar.
Covers the DC jack for charging the receiver collar unit.
Controls the power for the receiver collar unit, allowing it to be turned on or off.
Allows switching between single (fence only) and dual (fence/remote) modes.
Guidelines for placing the transmitter for optimal function and power.
Designing and positioning the boundary wire loop for the pet area.
Teaching the pet to recognize boundary flags and warning beeps.
Steps to remove a receiver collar from the remote trainer system.
Addresses issues where the remote trainer button press yields no stimulation.
Troubleshoots why the receiver collar's beeper is not making any sound.
Deals with problems where the stimulation from the collar seems weak or ineffective.
Explains why the receiver collar's light indicates low charge very quickly.
Addresses problems with significantly reduced or absent range for the remote trainer.
Troubleshoots when the receiver collar receives no signal or fails to work.
Resolves issues where the collar only activates when held directly on the boundary wire.
Addresses problems related to an inconsistent signal for the receiver collar.
Troubleshoots why the power light and loop indicator lights are off.
General| Feeding Times | Up to 4 meals per day |
|---|---|
| Material | Plastic |
| Battery | Rechargeable Lithium-ion Battery |
| Adjustable Levels | Yes |
| Capacity | Feeder: 5L |
| Portion Control | Not applicable |
| Voice Recording | Yes (10 seconds) |
To Next Page