My Pet Command DF113R - LED Light; DC Jack Cover; On;Off Button; Switch Single;Dual Mode

- 20 -
Receiver Collar
LED Light
This indicates the working
status, Low battery, and
Charging status
Contact Prong
Choose the short or long prong
to match your dog’s coat type
On/Off Button
Press and hold on 4 seconds to turn the collar on. Two confirming tones will sound and
the collar green LED light will flash 1 time per 5 seconds if connected/paired. The LED
will flash fast if disconnected/unpaired. Press and hold on 4 seconds to turn the collar off.
One long tone will sound and the green LED light will stop flashing and turn off.
Turn the collar off when not in use to conserve battery
Switch on/off Single mode and Dual mode.
Single mode: Fence function only , Green led flash 2 times per 5 seconds
Dual mode: Fence function and remote function both, Green led flash 1 time per 5
seconds
Press and hold on 2 seconds when receive collar is on , the Red LED light on then release
at once . The green LED will flash 2 times of 5 seconds. The fence function is on, the
remote function is off. It is Single mode now . Press and hold on 2 seconds again, the
Red LED light on then release at once . The green LED will flash 1 time of 5 seconds.
The fence function and remote function are both on .Now it is Dual mode .
DC Jack Cover
To charge, open the
rubber cover and
insert the adaptor
plug into DC Jack.