- 51 -
Check the Receiver Collar on/off
button, make sure the Receiver Collar
is turned on.
Check the Remote Trainer battery, it’s
power may be low.
Recharge the Remote Trainer or
charge the Receiver Collar if needed.
Problem#7: The Receiver Collar has to
literally be held on the top of Boundary
Wire for it to activate.
The batteries have may have run down.
Make sure the batteries are well
charged.
Adjust the Boundary Control Switch
knob clockwise to increase the
Boundary width.
Problem#8: I have an inconsistent signal
To Next Page
Loading...