Using your timer
Using the On/OFF buttons
Normal operation of your lights outside of programmed times
using the “on” and “off” buttons does not impact your pre-
programmed timetable.
Stop the programs from running
Holding the hour button for 7 seconds will cause a bar/line to
appear on top of the word ‘Auto’ on your LCD screen. This
signifies that your programmes are NOT active. The
programmed timetable still remains in the memory of your
light switch timer but will not run. In order to reactivate the
programmes again press the hour button until a bar above the
word ‘Auto’ disappears.
To Next Page
Loading...