STEP 1 – Installing the cradle
Turn off the power to the lights at the mains
1 - Using a screw driver, loosen both screws on the
switch plate - Eight to Ten turns of the screw is usually
enough to install the cradle. The screw does not need
to be fully removed.
2 - Slide the cradle between the wall and the switch
3 - Re-tighten the screws – taking care not to over
tighten the screw.
Turn the mains power back on.
Step 2 – install batteries
Insert two (2) high quality AA batteries into the battery
compartment in the rear of the unit as per the polarity
symbols (+ and -) indicated.
The LCD will flash AM 12:00, Mon (Monday), and OFF
STEP 3 – Setting time & Day
Press enter (temperature gauge will disappear)
To Next Page
Loading...