Remove the cradle by loosening the screws on the switch by a
few turns
• Insert the “n” shaped insert into
the recess of the cradle as shown.
• Re install the cradle.
• Re-tighten the screws and insert
the unit
Note the Inserts sit between the wall and the switch plate –
moving the switch forwards allowing the wheel to make
contact.
Why does the light switch timer do the opposite desired action
(turns lights on when they should be off and off when they
should go on)?
To turn lights on a switch is pressed ‘down’
To turn lights off a switch is pressed ‘up’
If this is not the case on your current set up, then your switch
To Next Page
Loading...