Setting up a new
myenergi hub
When you are setting up a new myenergi hub, there are a few steps
that you will need to follow to make sure that everything is up to
date.
1. Make sure that the new hub has the latest firmware installed
before
2. Pair! the new hub with your eddi and/or zappi
Setting up a new myenergi hub
Please follow the instructions below.! If you run into any problems
please contact our technical support team at
support@myenergi.com.au
(1) Plug the hub into the power and
Ethernet
Once the hub is plugged in you should see a green “power” light
and a blue “server” light
To Next Page
General