Zappi v2
1. When setting up a new myenergi hub, plug in the hub and
make sure that the power light is green
2. Now put the hub into pairing mode by briefly pressing the “pair”
button.
•
The power light on the hub will flash red and the “harvi /
Ch 1” LED should be blue
3. On the Zappi, pair with the new hub
•
From the main (graphic) screen, press the left hand
(“pizza box”) menu button to open the first page of the
menu.
•
To put the Zappi into Pairing Mode, use the down arrow
and the “+” button to select the following menu:
Settings… -> Advanced… -> 0 0 0 0 -> Linked Devices…
-> Pairing Mode…
4. The new hub should appear on the list of devices.! Make sure
it is selected and then press the “+” button
5. The screen will say “Updating Devices” before returning to the
“Devices” screen where the hub should now be listed
6. Keep pressing the left hand (“pizza box”) menu button to return
to the main (graphic) screen
To Next Page
Loading...
General