MyFlyDream Mini Crossbow - Digital data link via MAVLink; Installation and wiring; Tripod mounting

from the TeleFlyTiny module on the aircraft will be transmitted to the Crossbow AAT through the
serial port .
3. Transmitting information of the tracked target over a wireless digital data link from the
UAV to the ground station.
MAVLink protocol allows to transmit the information from the UAV through the digital radio link.
If the on-board system already includes the digital radio, and the flight controller that supports
MAVLink protocol, Crossbow AAT will be able to receive all flight information necessary to track
the UAV through the shared TXD line of the digital radio station.
4. For more specific applications requiring custom design of the signal transmission, please
contact MFD directly.
MyFlyDream miniCrossbow Specifications
Tracking Ability
MAX Pan-Speed
400deg/s
MAX Tilt-Speed
120deg/s
MAX Pan-Angle
360deg
MAX Tilt-Angle
0deg~90deg
Mechanical/Electrical
specifications
Weight
470g
MAX Tilt Torque
10kgf.cm
Operating
Voltage
12~16V DC
Power
Consumption
< 10W (Typical)
Protocol Interface
MFD VBI
All MFD Autopilots/TeleFlyPro/TeleFlyTiny
supported
MAVLink
MAVLink V1.0/V2.0 supported
2.Installation and wiring
1. The AAT can be fixed on the head of a regular camera/camcorder tripod by the means of a
standard 1/4-20 threaded interface at the bottom of the main unit. Make sure the tripod you use
is capable of supporting the size, weight, and leverage of the battery+AAT+Antenna assembly.
Correct choice of a tripod is the user’s responsibility. Please make sure that the quick release
plate of the tripod is compatible with the threaded interface on the bottom of the AAT main unit.