What to do if my Myline Spa Hot Tub has cloudy water?
If your Myline Spa Hot Tub water is cloudy, try these steps: Clean the filters, shock the spa with sanitizer, add sanitizer, and adjust the PH and/or alkalinity to the recommended range. You can also run the jet pump(s) and clean the filters again. If the problem persists, drain and refill the spa.
Why does my Myline Spa SATURN WM00177 Hot Tub have a water odor?
To address water odor in your Myline Spa Hot Tub, shock the spa with sanitizer, add sanitizer, or adjust the PH. If the odor persists, consider refilling the spa.
General| Brand | Myline Spa |
|---|---|
| Model | SATURN WM00177 |
| Category | Hot Tub |
| Language | English |
Details warranty periods, exclusions, and liability for the spa shell and components.
Information on obtaining warranty service through authorized dealers and installation requirements.
Lists specific actions or conditions that will void the spa's warranty coverage.
Precautions to prevent injury to children and bathers, including slippery surfaces and health.
Safety measures related to electrical connections and appliances near the spa.
Guidelines for preparing installation locations and general installation steps.
Steps for filling the spa, powering on, and priming the pumps, including air lock troubleshooting.
Basics of water recirculation, filtering, protecting the spa, and filter cartridge care.
Explains pH, water hardness, disinfection, frothing, and water analysis tools.
Solutions for water quality problems, spa inoperability, heating, and jets.
Overview of the control panel's physical layout and basic navigation.
Steps for filling the spa, priming pumps, and exiting priming mode.
Explains pump behavior, circulation modes, filtration, freeze protection, and clean-up cycles.
How to adjust set temperature and use dual temperature ranges.
Details on the differences and functions of Ready and Rest modes and Ready-in-Rest.
Instructions for setting time-of-day and flipping the display.
Procedures for locking panel functions and unlocking a restricted control panel.
Explanation of Hold Mode for service and Drain Mode for emptying the spa.
How to set main and optional filter cycles, including start times and durations.
How to enable and set the spa's lighting timer schedule.
Options for temperature display, time format, reminders, and cleanup cycles.
Information on system identification, heater settings, and accessing utility features like GFCI test.
Instructions for performing the GFCI test, including forcing the test and warnings.
Explanation of how to read and interpret fault log messages and data.
Explains standard messages like priming, temperature status, and safety trip alerts.
Troubleshooting for heater flow problems and dry heater conditions.
Explains sensor balance, failure messages, and communication loss.
Troubleshooting for memory, configuration, pump, and GFCI related system errors.
Details on reminders for pH, chemicals, filters, water changes, and cover care.
Guidelines for installation, CSA compliance, and general safety precautions.
Warnings regarding GFCI protection, shock hazards, and qualified technician service.
Instructions for piping connections, spa placement, and overall dimensions.
Technical diagram of wiring and explanation of S1 switch settings.
To Next Page