Safety Instructions
The installation must be carried out exclusively by the
authorized expert. When installing and connecting the relevant
standards must be observed.
Connect the current transducers to the power meter
first, afterwards attach to the wires of the house! Another
approach could lead to the induction of dangerous voltages
in the metering leads and/or damage the current
transducers!
When installing the current transducers, beware of
phase assignment and direction!
Any damage caused by ignoring the manuals is not covered by
the manufacturer’s warranty.
See also Operation Manual Power Meter.
Installation and technical characteristics
See also Operation Manual Power Meter.
Disposal
Either keep packing material or dispose properly.
Dispose of the product at the end of its service life in
accordance with the applicable regulations.
Connection via Router
To Next Page
Loading...
Need help?
General