Myson MEP3C User Manual

MYSON
www.myson.co.uk
MEP3C PROGRAMMER
EASY GUIDE
A
SETTING THE TIME
The time should be automatically set but if
you need to change it:
Move the slider to TIME/DATE position.
The hour will fl ash, use
+/- keys to adjust
up and down.
Use
>> button to move to minutes, date
and summer/winter time.
1
2
3
B
Programmer is mounted to wall and front fl ap
is normally in closed position.
Front fl ap opens up to display more buttons.
1
2
3

Myson MEP3C Specifications

General

CPU Socket	Socket 370
Max RAM	1.5GB
RAM Slots	3
RAM Type	SDRAM PC133
IDE	2
AGP	1 (AGP 4x)
USB Ports	2
Audio	AC'97 (onboard)

Summary

Setting the Time

Move to Time/Date Setting

Move the programmer's slider to the TIME/DATE position to begin time adjustment.

Adjust Hour

Use the +/- keys to adjust the flashing hour display up or down.

Set Minutes and Date

Use the >> button to navigate to minutes, date, and summer/winter time settings.

Setting the Programmer

Select Heating Mode

Move the slider to the HEATING position to set the programmer schedule.

Choose Programming Schedule

Use +/- buttons to select between 7-day, 5/2-day, or 24-hour programming options.

Set On/Off Times for Zones

Use >> and +/- buttons to set 'on' and 'off' times for Zone 1, then Zone 2.

Advance Function

Activate Run Mode

Move the slider to RUN position to enable temporary overrides like Advance.

Select Zones for Advance

Use the >> button to select the desired zones (Z1, Z2, HW) for the advance function.

Apply Temporary Override

Press the ADV button to temporarily override current times until the next scheduled setting.

Boost Function

Activate Boost Mode

Set the slider to RUN and use >> to select zones for boost.

Select Boost Duration

Press the +HR buttons once for 1 hour, twice for 2 hours, or thrice for 3 hours.

Deactivate Boost

Pressing the +HR button again will switch off the boost function.