7
RECOVERY TANK DRAIN
Located at the rear of the Mytee Lite™ is a bucket high
drain valve. Before extracting, screw on the included
A110 drain hose. When you’re nished extracting, un-
screw the T-handle cap on the hose to drain the tank.
VACUUM STACK FILTER
The Mytee Lite’s™ internal lter must be cleaned regu-
larly and is located in the recovery tank. Twist the lter
to remove then clean and replace. If the lter is torn or
damaged, replace with a new one.
VACUUM SWITCH
Turn on vacuum motor and begin cleaning. For best
results make two dry passes for every wet pass.
8070 MYTEE LITE™ OPERATION
EMPTY SOLUTION TANK
To empty any remaining water in the solution tank, remove
cap which is located at the front of the solution tank.
To Next Page
Loading...
