Need help?Do you have a question about the MyTek 8X192 ADDA and is the answer not in the manual?
General| Type | AD/DA Converter |
|---|---|
| Sample Rate | Up to 192 kHz |
| Bit Depth | 24-bit |
| Analog Inputs | 8 x TRS/XLR Combo |
| Analog Outputs | 8 x TRS/XLR Combo |
| Digital Inputs | AES/EBU, S/PDIF, ADAT |
| Digital Outputs | AES/EBU, S/PDIF, ADAT |
| Clock I/O | Word Clock In/Out |
| Channels | 8 channels |
| Dynamic Range | 120dB (A-weighted) |
| Dimensions | 19" x 1.75" x 10.5" (483 x 44 x 267 mm) |
Explains the two independent signal paths: ADC and DAC, and their operations.
Recommends using the internal clock generator for optimal performance and system stability.
Covers analog outputs, inputs, and their respective DB25 pinouts.
Details AES/EBU, DIO card slots, and expansion options for digital connectivity.
Explains DIP switch settings, clock generator, and power supply information.
Details volume control, attenuator, headphone output, and mute function.
Explains sample rate, WCK, and external clock source selection.
Describes output selection, signal routing, and meter indicators.
Guides on setting analog input and output levels for optimal sensitivity.
Details jumpers and trimpots for ADC gain configuration.
Details jumpers and trimpots for DAC gain configuration.
Covers DIOCARD headers and user-replaceable firmware EPROM.
Details Normal and Feed Through operations using the internal clock source.
Details Normal and Feed Through operations using external clock sources.
Describes Normal operation with external clock other than Wordclock.
Describes Feed Through operation clocked via Firewire.
Using the unit for format conversion with ADC off, monitoring digital input.
Technical details for the Analog-to-Digital Converter section.
Technical details for the Digital-to-Analog Converter section.
Specifications for digital outputs, sync, mains, and dimensions.
To Next Page
