II-2. Installation
- Choose a location that is free from rapidly changing temperature conditions (away
from a heating or cooling vent).
- To assure proper ventilation, allow a minimum of 5 Cm of the clearance between the
rear and side of the unit and the adjacent wall.
- Always ensure that the machine is installed on a level surface.
- In case of cable connection, after checking numbers indicated in its connector socket,
please match cable connector's hole with the pin of connector in equipment. Do not
connect or disconnect when remote box power is on.
<Connector Socket in Cable(left) and Remote Control Box>
- Before plugging the machine into the outlet, ensure that the electrical specifications
(listed on the serial number label on the rear side of the unit) matches the electrical
specifications of your outlet.
- Always
- Avoid a direct ray and light.
- Avoid dust air.
- Avoid connecting Shaker with Control before turning on the main
power (It causes unexpected error)
- Avoid discordance between Shaker's voltage and Incubator's voltage
To Next Page
Loading...