Need help?Do you have a question about the N-Zeta 501/01, 501/03 and is the answer not in the manual?
General| Category | Scooter |
|---|---|
| Fuel System | Carburetor |
| Brakes Rear | Drum |
| Tires Front | 120/70-12 |
| Tires Rear | 130/70-12 |
| Top Speed | 45 km/h |
| Engine Type | 4-stroke |
| Transmission | Automatic |
Details on the Jikov 2924 M 13 carburetor, its main jet, and float chamber.
Steps to dismantle the float chamber of the carburetor for maintenance.
Instructions for setting the carburetor per manufacturer specifications.
Carburetor details for specific Cezeta 501/03 to /05 models.
Carburetor details for specific Cezeta 502/00 to /01 models.
Maintenance and cleaning procedures for the induction silencer.
Steps for removing the cylinder head and barrel.
Information and procedures related to the piston, including grading.
Piston grading specifications and part numbers for Model 502.
Piston grading specifications and part numbers for Model 501.
Details concerning the cylinder and its bore specifications for grading.
Specifications for gudgeon pin bushes on Models 501/01, 03, 05.
Procedure for fitting the piston into the engine.
Steps for fitting the cylinder barrel and head.
Maintenance and removal of the cooling fan.
How to set and check the ignition advance timing.
Procedure for removing the dynastarter unit.
Steps to dismantle the clutch operating bracket.
How to remove the gearbox sprocket.
Procedures for dismantling the clutch and primary drive.
Steps to remove the kick starter quadrant.
Procedure for dismantling the gear change shaft.
Instructions for replacing crankshaft and gearbox seals.
Steps for removing the engine from the scooter frame.
Detailed steps for dismantling the gearbox and crankshaft.
Procedures for dismantling the crankshaft assembly.
Steps to remove the rear sprocket on Model 501.
Steps to remove the rear sprocket on Model 502.
Procedure for removing the rear drive chain on Model 501.
Procedure for removing the rear drive chain on Model 502.
Guidelines for maintaining the scooter's drive chain tension and lubrication.
Instructions for removing the front fork assembly.
How to remove the suspension damper on Model 501.
Dismantling suspension units on Model 502.
Steps to remove the chain case on Model 502.
Instructions for dismantling the pivoted rear arm.
Dismantling the pivoted rear fork on Model 502.
How to dismantle the headlamp assembly for both models.
Procedure for removing the fuel tank.
Steps to remove the luggage compartment.
Guide to removing bodywork and accessories.
Instructions for dismantling the choke device.
How to dismantle the fuel tap control.
Steps to dismantle the gear change pedal.
Explanation of the DC dynamo's function and operation.
Details on the PAL 6V voltage regulator.
Information on the PAL dynastarter system.
Details on the PAL 12V regulator and contactor.
How the dynastart system operates with its regulator and contactor.
Explains the dynamo's operation when the engine is running.
Technical data and setting for the PAL regulator with contactor.
Steps for mechanical checking of the regulator and contactor.
How to check the operation of the regulator.
Technical data for the PAL Dynastart.
Mechanical checks for the Dynastart system.
Checking the operation of the Dynastart.
Information on the scooter's lighting system, including bulbs.
Details about the electric horn and its location.
Information regarding the electrical leads and wiring harness.
To Next Page
