Need help?Do you have a question about the N-Zeta 502/01 and is the answer not in the manual?
Specific maintenance for the Jikov 2924 M 13 carburettor model.
Step-by-step guide to dismantling the carburettor float chamber.
Instructions for setting carburettor to manufacturer specifications.
Maintenance details for Jikov 2924 S 11 carburettor on specific models.
Maintenance details for Jikov 2924 S 13 carburettor on specific models.
Steps to dismantle the carburettor choke device.
Instructions for setting Jikov S 11/13 carburettors to manufacturer specifications.
Specific maintenance for silencer on 501/01, 03, 05 models.
Procedure for removing the cylinder head and barrel.
Information and procedures related to the engine piston.
Piston grading specifications for Model 502.
Piston grading specifications for Model 501.
Details and specifications for the engine cylinder.
Assembly data for cylinder models 501/01, 03, 05.
Assembly data for cylinder models 502/00, 01.
Information on gudgeon pin bushes for 501 models.
Information on gudgeon pin bushes for 502 models.
Instructions for fitting the piston into the cylinder.
Procedures for fitting the cylinder barrel and head.
Details and removal instructions for the cooling fan.
Guide for setting the engine's ignition advance timing.
Steps for safely removing the dynastarter unit.
Instructions for dismantling the clutch operating bracket.
Procedure for removing the gearbox sprocket.
Steps for dismantling the clutch and primary drive system.
Steps to remove the kick starter quadrant.
Instructions for dismantling the gear change shaft.
Guide for replacing critical crankshaft and gearbox seals.
Detailed steps for engine removal from the scooter frame.
Complex procedure for dismantling gearbox and crankshaft.
In-depth guide to dismantling the crankshaft assembly.
Technical data for connecting rod, rollers, and crank pin assembly.
Grading table for crankshaft assembly components in Model 502.
Specifications for connecting rods used in the 501 Model.
Specifications for connecting rods used in the 502 Model.
Step-by-step instructions for engine reassembly.
Procedure for removing the rear sprocket on Model 501.
Procedure for removing the rear sprocket on Model 502.
Steps for removing the rear drive chain on Model 501.
Steps for removing the rear drive chain on Model 502.
Guidelines for maintaining the drive chain tension and lubrication.
Steps for removing the front fork assembly.
Procedure for removing the suspension damper on Model 501.
Steps to dismantle suspension units on Model 502.
Steps for removing the chain case.
Instructions for dismantling the pivoted rear arm (Model 501).
Instructions for dismantling the pivoted rear fork (Model 502).
Steps to dismantle the headlamp assembly on both models.
Steps for dismantling and removing the fuel tank.
Procedure for removing the luggage compartment.
Guide for removing the main bodywork and associated parts.
Steps to dismantle the choke control mechanism.
Instructions for dismantling the fuel tap control.
Steps to dismantle the gear change pedal.
Detailed description of the dynamo and its function.
Information on the PAL 6V voltage regulator and its settings.
Details on the PAL Dynastarter system.
Information on the PAL 12V regulator and contactor.
Explanation of dynamo operation with the regulator.
Technical data and setting procedures for the regulator.
Guide for mechanical checks of the regulator.
Procedures for checking the regulator's operational parameters.
Technical data for the Dynastart.
Guide for mechanical checks of the Dynastart.
Procedures for checking the Dynastart's operational parameters.
Details on the scooter's lighting system.
Information regarding the electric horn installation.
Information on electrical leads and wiring harness.
To Next Page
General