3. Charge Procedure using N1C UPS
3.1. N1C LR-Series battery modules should only be connected to LR-Series N1C UPS
systems. Connection to any other equipment will void warranty and may be
hazardous.
3.2. Connection Steps:
3.2.1. Connect UPS to the battery module (CON 1 or CON 2) with supplied battery
cable.
3.2.2. Insert the COM Cable (RJ45 cable supplied in packaging) into the BMS COM port
on the battery module. The other end connects to the BMS communication port
of the UPS. (This cable is not used on the N1C.LR10000)
To Next Page
Loading...
