EasyManua.ls Logo

N1C LR Series - User Manual

N1C LR Series
20 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
LR-Series Lithium-
Iron Phosphate
Battery Module
(N1C.L4850EBM2U, N1C.L48100EBM3U)
Version: 1.1
User Manual

Table of Contents

Other manuals for N1C LR Series

Preview: Maintenance Guide
Maintenance Guide7 pages

Questions and Answers

  • B
    Brian RobertsAug 21, 2025
    What to do if my N1C Camera Accessories battery cannot charge?
    • L
      Laura AllisonAug 22, 2025
      If your N1C Camera Accessories battery won't charge, it might be due to a few reasons: * Over current protection may be active. In this case, ensure the power shelf setting is not over 1C for the battery. * The battery might be too hot or too cold (cell temperature below 0°C or above 60°C). Regulate the cell temperature to be between 0°C and 50°C for charging. * A system failure may have been detected. Shut down the system and call maintenance service.
  • S
    Sonya RichmondAug 30, 2025
    How to fix communication failure detected in N1C Camera Accessories?
    • T
      Theresa Ortiz DVMAug 30, 2025
      If a communication failure is detected in your N1C Camera Accessories, consider these potential causes and solutions: * Check if the communication cable is firmly connected. * There might be a communication address conflict. Check the parallel batteries address settings and correct them. * A system failure could be the cause. In this case, shut down the system and call maintenance service.
  • T
    Tonya GrayNov 10, 2025
    What to do if my N1C Camera Accessories battery cannot discharge?
    • L
      Leslie RodriguezNov 10, 2025
      If your N1C Camera Accessories battery isn't discharging, there could be several reasons: * Multiple battery packs might have the same ID code. If so, reset each battery with different ID codes. * It could be due to under-voltage protection. In this case, charge the battery. * The battery might be too hot or too cold (cell temperature below -20°C or above 80°C). Regulate the cell temperature to be between -20°C and 60°C for discharge. * Over current protection may be active. Remove some non-critical load and charge the battery. * There may be a short circuit in the battery output. Relieve the short circuit and charge the battery. * A system failure might have been detected. Shut down the system and call maintenance service. * If using parallel battery packs, CAN communicatio...

N1C LR Series Specifications

General IconGeneral
BrandN1C
ModelLR Series
CategoryCamera Accessories
LanguageEnglish