Need help?Do you have a question about the NACD SP318AM Series and is the answer not in the manual?
Provides an overview of the manual's purpose, scope, and where to get details.
Guidance on ordering spare or replacement parts using illustrations and lists.
Describes the SP318AM/SP318SBAM series PTOs, construction, and actuation.
Explains how to find the model and serial number on the unit's nameplate.
Details SAE housing identification and specifications.
Lists maximum safe operating speeds for NACD Take-offs.
Specifies requirements for support plates used in side-load and in-line applications.
Provides wear limits for bearing carrier bore dimensions based on part numbers.
Offers advice on installation, including bearing adjustments and alignment.
Details critical checks before installation, like engine crankshaft endplay.
Provides instructions for properly cleaning and installing the drive ring.
Instructions for installing ball-type pilot bearings.
Guides the process of mounting the PTO unit to the engine or driving member.
Explains the correct hand lever position for proper operation and throwout bearing life.
Details how to align sheaves for optimal belt/chain performance and longevity.
Provides information and formulas for determining allowable side loads on the PTO shaft.
Describes how to align components for U-joint type installations to ensure smooth operation.
Guides the setup and adjustment of air engagement mechanisms for clutch operation.
Explains the basic components and function of the NACD Power Take-Off.
Details the correct procedures for engaging the PTO clutch under various load conditions.
Provides general advice for maintaining the PTO unit, including bearing and clutch adjustments.
Specifies lubrication requirements, types of grease, and locations for the PTO.
Details the procedure for adjusting the clutch for optimal performance and wear.
Describes symptoms of worn friction plates and the procedure for replacement.
Explains how to adjust tapered roller bearings for specific PTO applications.
Outlines the procedure for safely removing the PTO unit from the engine.
Details the steps required to remove the clutch assembly from the PTO shaft.
Provides instructions for disassembling the clutch assembly.
Specific steps for disassembling the bronze collar component.
Specific steps for disassembling the ball bearing collar component.
Guides the removal of the operating shaft and throwout yoke assembly.
Detailed steps for disassembling the clutch shaft and housing for Configuration C.
Detailed steps for disassembling the clutch shaft and housing for Configuration D.
Provides instructions for washing, inspecting, and handling bearings.
Tips on keeping bearings clean and protected from contaminants.
Inspection guidelines for housings, cast parts, and machined surfaces.
Instructions for inspecting shafts, seal surfaces, and bearing journals for defects.
Detailed steps for assembling the clutch components, including throwout collars.
Guides the installation of the clutch assembly into the clutch housing.
A list of all illustrations included in the manual.
A comprehensive list of all parts with their corresponding numbers.
Exploded diagrams showing the assembly of SP318AM/SP318SBAM series clutches.
Exploded diagram illustrating the components of Configuration C.
Exploded diagram illustrating the components of Configuration D.
General| Brand | NACD |
|---|---|
| Model | SP318AM Series |
| Category | Intercom System |
| Language | English |
To Next Page