Nachi EZ-CFDL Series - Page 22

3.5 Tool constant settings
7
The tool length is calculated, and the results appear as follows a few moments
later.
>>The maximum error expresses the accuracy of the tool length which has been
calculated. The lower the value here, the higher the resulting accuracy of the tool
length which has been calculated.
The errors at each step
up to a maximum of 10
steps are displayed simultaneously.
If the results in
9
below are
not satisfactory, simply proceed to modify the position in
sequence starting with the step with the
highest value.
If satisfactory results have been obtained, select
[Yes] on the pop-up window,
and press [Enter] key.
>>At this stage, only the display is updated, and the data is not yet stored in the
constant file.
8
Upon completion of the settings, press the
<Complete> key. The settings are
now saved in the constant file.
>>Operation returns to the machine constant menu screen.
＋
9
Upon completion of the settings, check them.
Exit the constant menu and
try check go/back of program taught in
1
.
Sharp tip fixed on
the ground
Tool tip
If, unlike the movements which resulted when the
program was first taught, the tool
tip hardly moves at all from the sharp tip secured to the ground even during
operations between the steps, then the
tool length has been
set successfully
.
CAUTION
When pressing <Complete> key, following message will
appear. If programs are already
taught and these are not to be modified, please select [NO].