Nachi EZ-CFDL Series - Page 23

3.5 Tool constant settings
T
ool Length Automatic Setting
(2-point tool
length setting)
In order to easily set a new tool length when the shape of a tool is deformed,
2-point tool length setting
function
is prepared. In the case where the torch interferes during operation, or the torch is changed with a
new one, be sure to
use this function. By use of
this function, the tool length
after deformation is automatically
calculated. It is necessary to teach the task program before and after tool deformation as a calculation
program in advance.
1
First, it is necessary to teach the task program with the tool before deformation.
Carry out teaching (1 step) the task program which the attached tool tip (to
which a sharp end portion is attached too) is likely to target, to the sharp end
fixed to the ground.
Sharp tip fixed
on the g
round
Tool tip before
deformation
2
Next, it is necessary to
teach the task program with the tool
after deformation.
Carry out teaching (1 step) the task program in the same manner as in the
above
1
.
>>Set the tool posture same as that taught in the above
1
.
Tool tip before
deformation
Sharp tip fixed
on the g
round
3
In the tool constant setting screen of the desired tool number, press the <Easy
setting> key.
>>The 2-point teaching tool length automatic setting screen is displayed as shown
below.
4
If a different screen is
displayed, press the <2-Point Length Set>
key
.
5
Move the cursor on the program of the reference point before conversion, and
input the program number prepared in the above
1
 (for example, No.1), and
press [Enter] key.
6
Move the cursor on the step of
the reference point before conversion, and input
the step number prepared in the
above
1
(for example, No.1), and press [Enter]
key.