Nachi EZ-CFDL Series - 5.2 Ethernet setting

5.2Ethernet setting5.2Ethernet setting
5.2 5.2
Ethernet Ethernet
settingsetting
The Ethernet menu has following functions that The Ethernet menu has following functions that
are set in the are set in the
teaching mode / constant setting menu.teaching mode / constant setting menu.
This important setting shall be This important setting shall be
done by customer network administrator. For this controller, the operator licensedone by customer network administrator. For this controller, the operator license
ofof
SPECIALISTSPECIALIST
is necessary.is necessary.
TT
able 5.2.1 Constant setting able 5.2.1 Constant setting
menu of Ethernetmenu of Ethernet
Operation Operation
menu menu
DetailsDetails
TCP/IPTCP/IP
TCP/IP TCP/IP
is is
set. set.
Two Two
methods methods
are are
selectable:selectable:
Automatic setting Automatic setting
using using
DHCP or DHCP or
manual manual
setting setting
inputting inputting
each each
setting setting
value.value.
When manual input of each value is selected, input the IP address and theWhen manual input of each value is selected, input the IP address and the
subnet mask etc.subnet mask etc.
FTPFTP
FTP is set.FTP is set.
This menu can change the FTP server setting set in the Microsoft InternetThis menu can change the FTP server setting set in the Microsoft Internet
Information Information
ServerServer
..
IMPORTANTIMPORTANT
When ”system memory protection function” has been set to enabled,When ”system memory protection function” has been set to enabled,
”system memory protection function” is needed to be changed “disabled” before the”system memory protection function” is needed to be changed “disabled” before the
setting of section “setting of section “
5.2.1TCP/IP setting5.2.1TCP/IP setting
” or “” or “
5.2.25.2.2
FTP settingFTP setting
”.”.
(1) Change the operator qualification to(1) Change the operator qualification to
EXPERTEXPERT
or higher.or higher.
(2) Proceed to <Service Utilities> - [13 (2) Proceed to <Service Utilities> - [13
System Environments].System Environments].
(3) Check the setting (3) Check the setting
of System Memory Protection Functionof System Memory Protection Function
5.2.1 5.2.1
TCP/IP TCP/IP
settingsetting
TCP/IP SettingsTCP/IP Settings
11
Select Teaching Mode.Select Teaching Mode.
22
Select <Constant setting> –Select <Constant setting> –
[[
8 Communication] – [2. Ethernet] – [1 TCP/IP].8 Communication] – [2. Ethernet] – [1 TCP/IP].
>> >>
Setting screen of TCP/IP appears as shown below.Setting screen of TCP/IP appears as shown below.
33
Set the necessary parameter referring to "Table 8.2.2 TCP/IP setting".Set the necessary parameter referring to "Table 8.2.2 TCP/IP setting".
44
When the setting is completed, press f12 When the setting is completed, press f12
<Complete>.<Complete>.
55
TT
o enable the o enable the
new settings, restore the new settings, restore the
power of the power of the
robot controller.robot controller.