Nachi EZ-CFDL Series - 5.3 File transfer (FTP client)

5.3File transfer (FTP client)
5.3
File
transfer
(FTP
client)
Files are transferred using the operation menu of this controller. This controller works as an FTP client (the
node to start the FTP requirement). To use FTP client function, Ethernet Setting such as TCP/IP and FTP shall be
completed beforehand. The details are given in
"
5.2
Ethernet setting
".
FTP
File transfer
PC
FTP client
Robot controller
Operator
FTP server
Fig. 5.3.1 File transfer
with robot controller as FTP client
5.3.1
Registrations
of
FTP
Server
(Host)
Before using the FTP client function, it is necessary to set a host, which will be the FTP sever for
connection, according to the following steps.
Up to 2 FTP servers can be connected to this controller. This is an important setting and must be made by
your network administrator. Operator qualification as the
SPECIALIST
is nece
s
sary.
Registrations of FTP Server (Host)
1
Press f4 <File>.
When soft keys are not provided, service
menu can be used
for entry
. In this
case, select [7. File Manager] from service menu and press [Enter] key
>> File manager menu such as the
following is opened.
2
Align the cursor on the
[8 File Transfer (Ethernet FTP)] and press [Enter] key.
>> A screen such as the following is
displayed.