NAD PP 375 User Manual

PP 375 Phono Preamplifier Module
Mounting Instruction
The PP 375 Phono Preamplifier module comes with flat flexible cable and screws.
Please do the following steps for proper installation of the module.
Step 1
Insert one end of the flat flexible
cable into the connector on
PP 375 module and the other
end into P214B connector on the
main board of C375BEE, as shown.
Ensure the contacts is facing
the terminals on the connectors
and fully inserted.
Step 2
Remove the dummy cover at the
back of the main C 375BEE unit and
replace with PP 375 module.
Secure with 2 screws at the rear
panel on the main C375BEE unit.
Step 3
Tidy up the flat cable by flexing
its slack underneath the module,
as shown.
Mount the top cover and begin
your experience with PP 375.
Please visit www.NADelectronics.com
if you need fu rther i nformati on.
Unplug Main unit from Power before opening to Install Preamp

NAD PP 375 Specifications

General

Brand	NAD
Model	PP 375
Category	Control Unit
Language	English

Summary

PP 375 Phono Preamplifier Module Mounting Instruction

Step 1: Connect Flat Flexible Cable

Insert one end of the flat flexible cable into the PP 375 module connector and the other end into the P214B connector on the main board.

Step 2: Install Module and Secure

Remove the dummy cover from the back of the main C 375BEE unit, replace it with the PP 375 module, and secure with two screws at the rear panel.

Step 3: Tidy Cable and Mount Cover

Tidy the flat cable by flexing its slack underneath the module, then mount the top cover to complete the installation.

PP 375 Phono Preamplifier MDC Module Overview

Product Features

Highlights key features like fantastic vinyl playback, MDC modular design, award-winning circuit, and seamless integration.

Technical Specifications

Details input sensitivity, overload, RIAA accuracy, THD, S/N ratio, and channel separation for Moving Coil and Moving Magnet cartridges.