NAD VISO 1 - Component Video Output; Extended Mode for iPod; Near Field Setup; Factory Default Settings Reset

COMPONENT VIDEO OUTPUT
Using compatible iPod models, one can playback a stored video in one’s
iPod and view the video via VISO 1 by making use of the following methods
Y Pb Pr
• If your particular iPod model supports component video signal, connect
VISO 1’s Y, Pb and Pr output terminals to the corresponding Y, Pb, Pr
(Component Video) input terminals of a compatible TV.
• Switch your TV to the corresponding Component Video input to view
your iPod’s video playback.
• Press and hold [4j] to toggle iPod video output between the
connected TV and the iPod’s own display screen. Depending upon your
iPod model, video playback can be resumed by consequently pressing
the applicable iPod buttons.
Pb
• If your particular iPod model does not support component video signal but
supports composite video signal, connect only VISO 1’s “Pb” output terminal
to the corresponding composite video input of a compatible TV.
• Switch your TV to the corresponding Composite Video input to view
your iPod’s video playback.
Check with your iPod distributor which video signal your particular iPod
model supports.
EXTENDED MODE
When you dock your iPod into VISO 1 and a check mark appears and “OK
to disconnect” is shown in the iPod display screen, it means that your
particular model can only be played back by VISO 1 in Extended Mode.
The following applies to your applicable iPod model in Extended Mode.
• The click wheel is non-functional.
• Access to iPod menu is not possible.
• Playback of the rst song automatically starts after docking the iPod.
NEAR FIELD
The NAD VISO 1 includes a special feature that subtly reduces the amount
of high frequency power to optimize performance for ‘near eld’ listening.
You may prefer this setting if you listen at a very close distance or have a
very small room. For most installations the factory setting is correct.
NEAR FIELD SETUP
1 Press and hold “S” button until the blue POWER indicator ashes
continuously.
2 While the blue POWER indicator ashes continuously, press “-” to set
Near eld mode.
3 VISO 1 remains in Field mode and the blue POWER indicator remains
ashing. If there is no activity for 5 seconds, the VISO 1 will default back
to normal mode and the blue POWER indicator stops ashing.
RESTORING VISO 1 TO ITS FACTORY DEFAULT SETTINGS
Sometimes power spikes and drop-outs may from time to time cause some
inadvertent functionality. The procedure below will reset the VISO 1 to its
factory default settings.
1 Press and hold “+” and then press POWER button to turn ON the VISO 1.
2 Release “+” when the POWER indicator turns blue and ashes three
times. VISO 1 will continue on to initialize.
VISO 1 FEATURES
8
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ