NAIM NDX 2 - NDX 2 Connection and power; Connecting the NDX 2; Powering on the system

E
Power
connection
NDX 2 Connection and power
(A) Firstly turn off your hi-fi system. (B) Connect the ethernet network cable
from router to streamer (if unavailable connect 2 x Wi-Fi antennae instead)
and 1 x Bluetooth antenna to the rear of the unit. (C) Connect the Burndy link
plug to the back of the unit. (D) Use the interconnect lead (5-5pin DIN)
to connect to the pre-amplifier of your hi-fi system. (E) Connect the power
lead to the unit’s power socket and to the mains. (F) Then switch on
the streamer by pressing the front power button.
() Turn your hi-fi system back on.
Router
To pre-
amplifier
B
DC
Fit Burndy
link plug
A
Power off your
hi-fi system
F

Switch on
streamer
Power on
your system
5