NAIM UnitiLite - Installing and Connecting UnitiLite; Wi-Fi and Bluetooth Aerials; USB Device Compatibility; Switching On and Getting Started

Page 4 of 15 26/03/2010
NaimUniti Troubleshooting Guide.doc
1.6
1.61.6
1.6 The display turns off quickly even if Aut
The display turns off quickly even if AutThe display turns off quickly even if Aut
The display turns off quickly even if Auto off is set to one hour
o off is set to one houro off is set to one hour
o off is set to one hour
• Check the display has not been switched off with the ‘disp’ button.
1.7
1.71.7
1.7 “I sometimes accidentally change input when pressing up/down when not in
“I sometimes accidentally change input when pressing up/down when not in “I sometimes accidentally change input when pressing up/down when not in
“I sometimes accidentally change input when pressing up/down when not in
a list”
a list”a list”
a list”
• This functionality can be switched off in the menu. From the setup menu select
‘Handset Keys > Up/Down’ to change the way the Up/Down keys behave. This
menu also has a setting to define the operation of the Left/Right keys.
2
22
2 Audio Problems
Audio ProblemsAudio Problems
Audio Problems
2.1
2.12.1
2.1 No subwoofer output
No subwoofer outputNo subwoofer output
No subwoofer output
• Check the subwoofer lead is connected
• Check the subwoofer is switched on and the fuse is ok.
• Check subwoofer is switched on in ‘Setup > Speakers’ menu.
2.2
2.22.2
2.2 One input is much louder than another
One input is much louder than anotherOne input is much louder than another
One input is much louder than another
• Use the Input trim settings for each input to adjust the level of each input.
2.3
2.32.3
2.3 No sound on Headphones or Speakers
No sound on Headphones or SpeakersNo sound on Headphones or Speakers
No sound on Headphones or Speakers
• Check the volume is not set to 0 or mute.
• Note that the NaimUniti stores a separate volume setting for headphone use and
automatically selects it when the headphones are inserted.
2.4
2.42.4
2.4 No input on Front input when using digital or analogue source
No input on Front input when using digital or analogue sourceNo input on Front input when using digital or analogue source
No input on Front input when using digital or analogue source
• Check that the front panel input has not been set to the wrong audio format in the
‘Setup > Inputs > Front > Format’ menu
2.5
2.52.5
2.5 Start of track cut when using front panel digital input
Start of track cut when using front panel digital inputStart of track cut when using front panel digital input
Start of track cut when using front panel digital input
• The NaimUniti takes a short amount of time to detect the incoming signal when a
device is first attached to the front panel input. Setting the input to use the desired
format in the ‘Setup > Inputs > Front > Format’ menu can speed up the time taken
to detect the format.
2.6
2.62.6
2.6 Bass appears to be missing from the main loudspeakers
Bass appears to be missing from the main loudspeakersBass appears to be missing from the main loudspeakers
Bass appears to be missing from the main loudspeakers
• Check that the main loudspeakers are set to ‘Large’ in the ‘Setup > Speakers’
menu.
2.7
2.72.7
2.7 Main volume doesn’t go all the way to 100
Main volume doesn’t go all the way to 100Main volume doesn’t go all the way to 100
Main volume doesn’t go all the way to 100
• The maximum allowed volume can be set in the ‘Setup > Speakers > Max. Volume’
menu.