What to do if Nakanishi Sonic ZERO Cutter shows handpiece overload error?
If your Nakanishi Cutter handpiece displays an overload error, it means there's too much load or force on the blade. Try reducing the cutting pressure or the force you're applying.
Why Nakanishi Sonic ZERO shows amplifier error?
If you are experiencing an amplifier error with your Nakanishi Cutter, it is likely due to board heat generation. To resolve this, allow the unit to cool down completely before turning it back on. Ensure you are not putting excessive load on the blade and verify that the blade is securely tightened.
What to do if Nakanishi Sonic ZERO Cutter shows resonance frequency search timeout?
If the Nakanishi Cutter exhibits a resonance frequency search timeout, it indicates that the resonant frequency of the installed tool, tip holder, or tip could not be found. Check if the blade is loose and tighten it firmly.
Why Nakanishi Sonic ZERO Cutter shows frequency pull-back anomaly?
If your Nakanishi Cutter displays a frequency pull-back anomaly, it means the resonance frequency is changing significantly during operation. Check to ensure the blade is not loose and tighten it firmly.
What to do if Nakanishi Cutter handpiece fever abnormality?
If the Nakanishi Cutter handpiece becomes abnormally hot, check for a loose blade and tighten it firmly.
How to fix system error on Nakanishi Sonic ZERO Cutter?
If your Nakanishi Cutter is experiencing a system error, please return the complete unit for service.
What to do if Nakanishi Cutter has excessive input voltage?
If you're encountering an issue with excessive input voltage on your Nakanishi Cutter, please return the complete unit for service.
What to do if Nakanishi Sonic ZERO shows under input voltage?
If your Nakanishi Cutter is showing an under input voltage error, please return the complete unit for service.
What to do if Nakanishi Sonic ZERO Cutter shows amplitude feedback residual voltage error?
If your Nakanishi Cutter displays an amplitude feedback residual voltage error, please return the complete unit for service.
What to do if Nakanishi Cutter shows start frequency confirmation error?
If the Nakanishi Cutter shows a start frequency confirmation error, please return the complete unit for service.
To Next Page
General