Nakayama PRO EB1010 - Specifications; Technical Data

WWW.NIKOLAOUTOOLS.GR
2
1. Blade
2. Blade guard
3. Tube
4. Knob
5. P handle
6. Shoulder harness
7. Safety lock-o buon
8. Switch trigger
9. Handle (with so paint)
10. Housing
11. Spool set
12. Spool guard
13. Spanner
Technical Data
Model EB1010
Rated voltage 220V / 50Hz
Rated power 1000W
No load speed 7500/min (blade), 7500/min (spool)
Cung width 230mm (blade), 350mm (spool)
Blade type 3 teeth
Line feed system Bump-head
Line type 5m x 2.0mm
Cable length 0.25m
Features Split sha, U handle
SPECIFICATIONS
* The manufacturer reserves the right to make minor changes to product design and technical
specicaons without prior noce unless these changes signicantly aect the performance and safety
of the products. The parts described / illustrated in the pages of the manual that you hold in your hands
may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspecon, repair
or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operaon of the product with non-provided
equipment may cause malfuncons or even serious injury or death. The manufacturer and the importer
shall not be liable for injuries and damages resulng from the use of non-conforming equipment.
EN