Need help?Do you have a question about the Nalnor HRU-SlimAIR and is the answer not in the manual?
Describes the components and function of the HRU-SlimAIR ventilation system.
Provides guidance on how to effectively use the user manual for installation and operation.
States that the original manual was written in English and other versions are translations.
Explains the meaning of 'WARNING' and 'NOTE' symbols used in the manual.
Outlines essential safety precautions for installation, operation, and maintenance of the unit.
Lists applicable directives and standards (ERP, LVD, EMC, EN standards) for the product.
Specifies the physical dimensions of the HRU-SlimAIR unit (HxWxD).
States the weight of the HRU-SlimAIR unit.
Identifies the type of heat exchanger used in the unit.
Specifies the type of fans used in the HRU-SlimAIR.
Details the type and operation of the unit's by-pass.
Indicates the types of filters supplied with the unit.
Confirms the presence of a built-in pre-heater in the unit.
Describes the available installation orientations for the unit.
Provides air flow rate specifications for different models at a given pressure.
Lists the heat recovery efficiency percentages for different models.
Specifies the maximum internal leakage rates according to EN standards.
Specifies the maximum external leakage rates according to EN standards.
Details the contents of the complete set included with the heat recovery unit.
Guides on how to install the unit in a vertical wall position.
Provides instructions for installing the unit in a horizontal wall position.
Explains the procedure for suspending the unit from the ceiling.
Defines the minimum clearances required around the unit for maintenance access.
Describes how to connect the unit to the electrical power supply.
Explains the meaning of the LED indicator light for unit status and faults.
Details the process and duration of the binding mode for accessory pairing.
Outlines different control methods and modes available for the unit.
Describes the capability and function of the unit's temperature sensors.
Explains the mechanism and algorithm for frost protection.
Details the operation principles and conditions for the built-in pre-heater.
Explains the function and operation of the bypass mechanism.
Describes how passive heating is utilized using outdoor air.
Describes how passive cooling is utilized using outdoor air.
Outlines the conditions under which the emergency stop function becomes active.
Explains the parameter for automatically returning the unit to auto mode.
Provides information on the filters supplied with the unit and optional upgrades.
Details the procedure for cleaning the heat exchanger.
Explains how to connect an optional ground heat exchanger.
To Next Page
General