Page 53
6-11 Replacing the Drive Sensor PC Boards
1.Remove the Drive Assy. (see 6-10 page 52)
2. Unsolder the wires from the Sensor Pc Board. (Note the positions of each wire so
that they are refitted correctly on the new PC Board).
3. Remove 2off pozi flange screw (M3x6) and remove the Sensor PC Board.
4. Refit the new Sensor PC Board and resolder the wires.
5. Reassemble into the cabinet.
Sensor PC Board
(Front)
Pozi flange screw
(M3x6)
Sensor PC Board
(Rear)
Pozi flange screw
(M3x6)
+5v
SIG
GND
Orange
Light Blue
Brown
Sensor PC Board
(Rear)
Sensor Pc Board
(Front)
Brown (x2)
Light Blue (x1)
Orange (x2)
Brown (x1)
Green/Yellow (x1)
Orange (x1)
Wire Connections
To Next Page
Loading...