Page 54
6-12 Replacing the Solenoid
1.Remove the Drive Assy. (see 6-10 page 52)
2. Unsolder the wires from the Solenoid. (Note the positions of each wire so that
they are refitted correctly on the new Solenoid).
3. Remove the button head screw (M3x12) and nylon nut, 2off socket head screw
(M2.6x5) and remove the Solenoid.
4. Refit the Solenoid with Diode attached, and reconnect the solenoid wires as
shown below.
5. Refit the Drive Assy to the cabinet.
Lock Finger
Socket head screw
(M2.6x5)
Nylon nut
(M3)
Solenoid
White/Violet
Violet
Diode
(attached to
solenoid)
White/Violet
Violet
Button head screw
(M3x12)
To Next Page
Loading...