NAMCO Quick & Crash - Replacing the Gun Harness Assy

Page 101
7-35 Replacing the Gun Harness Assy
1.Remove the Fibre Optic Cable. (See section 7-30 page 93)
2. Remove 2off cap bolts (M3x6) and remove the Harness Guide from the Pipe
Bracket.
3. Remove 1off Pozi head screw (M5x20), Hex nut (M5) and unfasten the Pipe Clip
and Pipe Bracket.
4. Remove 1off cap bolt (M3x20), 1off cap bolt (M3x8), 2off hex nut (M3) and
remove the Hand Protectors (L) and (R).
Harness Guide
Pipe Bracket
Hex Nut (M5)
Pozi Head Screw
(M5x20)
Pipe Clip
O Ring
Hex Nut (M3)
Hand Protector (L)
Hand Protector (R)
Cap Bolt
(M3x8)
Cap Bolt
(M3x20)