Page 103
Tie Wrap
Gun Bracket
10 Reassemble in reverse order.
Note: The tie wraps on the Gun Harness Assembly should be installed so that they
come in contact with the gun bracket, as shown in the diagram below.
Note: Install the Fibre Optic Holder by aligning the marking on the holder with the
marking on the gun side (L). (see step 4 section 7-34 page 99).
It is recommended that ThreeBond 1401 screw lock, (part No 95000006), is
applied to the cap bolt (M3x20), cap bolt (M3x8), and 2off hex nut (M3) when
reassembling the gun harness assy
To Next Page
Loading...
