NAMCO Quick & Crash - Replacing the [SET] and [START] Lamps

Page 89
7-27 Replacing the [SET] and [START] Lamps
1. Remove 6off security screws (M4x25), with flat washers, and remove the
Set / Start Acrylic.
2. Remove the lamp by turning it in the direction of the arrow, shown in the diagram
below.
3. Reassemble in reverse order.
Security Screw
(M5x25)
Gun Cabinet
Set / Start Acrylic
Washer
(M4)
[SET] Lamp
(24v 15w)
[START] Lamp
(24v 15w)
Front