Page 95
Holder
Xenon Tube
Xenon PC Board
Insert the Fibre Optic until
it comes in contact with
the stopper in the holder
and install it so that it is as
close as possible to the
Xenon Tube.
Fibre Optic
5. Reassemble in reverse order.
Note: In order to ensure the correct light output from the gun Assy, the fibre optic
should be fitted as close as possible to the Xenon Tube.
When installing the fibre optic, be careful not to touch the Xenon tube with your
fingers or hands. If the Xenon tube is accidentally touched, clean the area
touched with alcohol. (Part No 95000031)
To Next Page
Loading...
