55
TOT
1. The purpose of the Time-out Timer is to prevent any
single person from using a channel for an extended period
of time.
2. The overtime can be set by PC software programming
( the time can set as 30 seconds, 60 seconds, 90 seconds、
120 seconds、150 seconds、180 seconds or OFF ). If the
continue launching time is over the preset timer, the
launching will be stopped and a “Bi” tone sounds. To stop
the “Bi” tone, please release the PTT button. You can press
the PTT button again to resume launching.
Oral Channel Indicator Function
Open the PC software to choose the language you like.
When the oral channel indicator function is programmed to
be off, then the transceiver will not report the channel.When
the oral channel indicator function is programmed to be in
English or in Chinese, then the transceiver will report the
channel.
Scan Function
1. Open the PC software to choose the scan should be
turned on or not. There are two kinds of scan, one is
“carrier wave”, and the other is “time”
2. When you choose carrier wave, you can select the
function in each channel. There’re scan function options
Function Setting
Professional Handheld FM Transceiver
To Next Page
Loading...
