16
Notice
1. The wire controller is only compatible with PavoBulb 10C and PavoTube T8-7X.
2. When the battery level is low, it is recommended to reduce the brightness to less than 50% for charging, or turn it
off and fully charge before using again.
3. When the wire controller is not connected to the fixture and is powered off, connect the power supply, now the
display will show " " and icon is scrolling; when the battery is fully charged, the display shows " ".
7. USB Type C port: For firmware updates, or connect with the USB cable, and then connect to the USB adapter with
an output of 5V/2A or above to charge the wire controller.
8. The wire controller has a built-in lithium battery and can power the PavoBulb 10C and PavoTube T8-7X directly.
9. Please switch off the controller when not in use.
This manual has been compiled according to the rigorous testing of our company's products. Product designs are
subject to change without prior notice. You can download the latest version of the manual for this particular product
from www.nanlite.com.
To Next Page
Loading...