Need help?Do you have a question about the NANLUX Evoke 1200 and is the answer not in the manual?
General| Power | 1200W |
|---|---|
| Dimming | 0-100% continuous |
| Power Supply | AC 100-240V, 50/60Hz |
| Power Consumption | 1200W |
| Operating Voltage | AC 100-240V |
| Cooling System | Active Cooling (Fan) |
| Control | DMX, Bluetooth |
| Type | LED |
| CRI | 96 |
Mechanism for attaching and detaching the yoke.
Mount for attaching reflectors or other accessories.
Secures or releases mounted accessories.
Attachment point for safety ropes.
Supports the fixture for stand mounting and tilting.
Shows operational data and status.
Buttons for controlling modes like DAYLIGHT, EFFECT, MENU, LOCK.
Adjusts brightness and other parameters.
For firmware updates and device connection.
Input port for DMX signal.
Used to adjust the fixture's direction.
Controls the tilt movement of the fixture.
Used for selecting options and settings.
Interface for wire control.
Power input port for DC power.
Output port for DMX signal.
For quick installation and detachment of yoke.
For installation of reflector or other NL mount accessories.
To lock or release the reflector or other accessories.
For hanging safety rope.
Mount the fixture on a stand, pan and tilt.
To display data.
Including DAYLIGHT, EFFECT, MENU and LOCK.
For adjusting brightness and other parameters.
For updating firmwares or connecting USB cable to external devices with maximum current of 5V/1A.
DMX signal input interface.
Adjust the direction of the fixture.
Tighten or release the tilt movement of the fixture on the yoke.
For selecting options.
Wire control interface.
DC power input interface.
DMX signal output interface.
For safely hanging the power supply.
For connecting the fixture to the power supply with DC cable.
For determining the status of power input.
To turn on/off the fixture.
For connecting AC power supply.
Steps for connecting the light fixture to its power source.
Procedures for attaching and removing the yoke.
Steps to install and remove the reflector.
How to attach the Fresnel lens and barndoor.
Configure DMX address, mode, and dimming curve.
Connecting and controlling via DMX.
Using the 2.4G wireless remote.
Controlling the fixture using RDM protocol.
Utilizing LUMENRADIO for wireless control.
Overview of the fixture's display and basic controls.
How to use the EFFECT key to access and control lighting effects.
Navigating the main menu options using the MENU key.
Instructions for managing the fixture's cooling fan.
How to change the display orientation.
Adjusting the brightness of the display screen.
Control over the backlight for physical buttons.
Setting the display language.
Checking the firmware version of the fixture.
How to lock and unlock all fixture functions.
To Next Page
