Do you have a question about the Nanosonics Trophon EPR and is the answer not in the manual?
Brand | Nanosonics |
---|---|
Model | Trophon EPR |
Category | Laboratory Equipment |
Language | English |
Provides general information about the trophon EPR, including validated probes and user training requirements.
Details critical warnings, labels, and symbols associated with the trophon EPR for safe operation.
Describes the front, back, chamber, and side panels of the trophon EPR device, identifying key components.
Covers the essential steps for installing the trophon EPR, including positioning, cable management, powering on, and basic settings.
Explains how to handle and load the disinfectant cartridges, including safety precautions and spillage procedures.
Details the process for performing a high-level disinfection cycle, including probe preparation and positioning.
Outlines the reasons for and procedure to run a purge cycle to remove disinfectant and prepare the device for transport.
Provides instructions for safely removing and disposing of used disinfectant cartridges, including handling precautions.
Addresses common issues like power failure or cycle faults, offering solutions and guidance for troubleshooting.
Describes periodic cleaning procedures and when to contact for device service.
Explains the process for decommissioning and disposing of the trophon EPR unit.
Introduces the trophon Printer, its features, and initial setup procedures.
Covers replacing the label roll and cleaning the trophon Printer.
Provides guidance on connecting/disconnecting the printer and troubleshooting error messages.
Information on proper disposal of the trophon Printer for EU member states.
Details how to reorder trophon Printer supplies like the printer, cables, and label rolls.
Lists the electrical, environmental, physical, and safety specifications for the trophon Printer.
Provides detailed technical specifications for the trophon EPR, including electrical, environmental, physical, and EMC compliance.
Contains information on the product warranty terms, conditions, and the registration form.