1
1. RECEIVER INSTALLATION
The receiver (W660-0076) can be installed as either a wall mount
A
or a appliance mount
B
. Depending on your application, follow the applicable
steps below after having completed step 1.1.
Turn off the electrical power and the gas supply to the appliance. Make sure the slide
switch on the receiver is set to the “OFF“ position.
1.1 Either disconnect the existing switch wiring at the valve, or connect in parallel with
any other switch wiring at the valve. For millivolt switch wiring attach the wires to terminal 1
(marked TPTH) and terminal 3 (marked TH) of the gas valve from the output terminals on the
receiver. FIGURE 1 NOTE: If connecting the receiver to an appliance with electronic
ignition, connect the receiver wires to the two leads from the control module, identifi ed
as switch wires. (It may be necessary to remove the spade connectors and join the
wires using wire connectors)
A
RECEIVER WALL MOUNT
1.2 Press the battery compartment slightly into the receiver and release enabling the battery compartment to pop out. Pull off the slide switch. Slide the
receiver out of the wall mounting plate. FIGURE 2
1.3 Using the screws provided secure the receiver and the wall face plate to an existing junction box. FIGURE 2
1.4 Replace the black slide switch with the white one included to match the cover plate. Place 4 AA batteries into the battery compartment and slide the
compartment back into the receiver. FIGURE 3
1.5 Turn on the electrical power and the gas supply to the appliance.
F45, F60 AND F60D UNIVERSAL REMOTE
INSTALLATION AND OPERATION
INSTRUCTIONS
GAS VALVE
TP TH TP TH
RECEIVER
1
3
FIGURE 1
FIREPLACE REMOTE
OFF
ON
REMOTE
BAT.LOW
JUNCTION
BOX
RECEIVER
SLIDE
SWITCH
WALL FACEPLATE
WALL MOUNT
INSTALLATION
FREQUENCY
ADJUSTMENT
SCREW
FIREPLA
CE REMO
TE
OF
F
ON
R
EMO
TE
BA
T.LO
W
BATTERY
COMPARTMENT
BATTERY
INSTALLATION
STICKER
(See 7. FINISHING)
FIGURE 2
FIGURE 3
QTY. PART# DESCRIPTION
1 W660-0066 Transmitter
2 N043-0002 “AAA” Batteries
1 W080-0930 Wall Mount Cradle
1 W660-0076 Receiver
1 W500-0405 Wall Faceplate
1 W500-0404 Fireplace Mounting Plate
1 W660-0080 Slide Switch
4 W043-0002 “AA” Batteries
Included with the F45 Universal Remote:
Included with the F60 Universal Remote:
QTY. PART# DESCRIPTION
1 W660-0067 Transmitter
2 N043-0002 “AAA” Batteries
1 W080-0930 Wall Mount Cradle
1 W660-0076 Receiver
1 W500-0405 Wall Faceplate
1 W500-0404 Fireplace Mounting Plate
1 W660-0080 Slide Switch
4 W043-0002 “AA” Batteries
Included with the F60D Universal Remote:
QTY. PART# DESCRIPTION
1 **W660-0087 Transmitter
2 N043-0002 “AAA” Batteries
1 **W080-1050 Wall Mount Cradle
1 W660-0076 Receiver
1 W500-0405 Wall Faceplate
1 W500-0404 Fireplace Mounting Plate
1 W660-0080 Slide Switch
4 W043-0002 “AA” Batteries
**FOR OTHER AVAILABLE COLOURS, ADD THESE LETTERS TO THE BASE PART NUMBER: COLOUR LETTER
BLACK K
GREY Y
RED R
www.FireplaceRemoteControls.com
To Next Page
Need help?
General
