Why is my Napoleon Indoor Fireplace not producing warm air?
Your Napoleon Indoor Fireplace may not be producing warm air because the heater setting hasn't been selected or the heater has been locked out. Please refer to the “operation” section for instructions.
What to do if my Napoleon Indoor Fireplace remote control does not work?
If your Napoleon Indoor Fireplace remote control isn’t working, try these steps: * Replace the batteries in the remote control, as low or dead batteries are a common cause. * Ensure that the remote receiver is not blocked. If it's still not working, the control panel may need to be replaced.
What to do if my Napoleon NEFL50B-1 Indoor Fireplace appliance has overheated and safety thermal switch has tripped?
If your Napoleon Indoor Fireplace has overheated and the safety thermal switch has tripped, unplug the power or turn off the circuit breaker. Let the appliance cool down for 15 minutes.
What to do if my Napoleon NEFL50B-1 LED is flashing?
If the LED on your Napoleon Indoor Fireplace is flashing, it might be because the appliance has overheated and the safety thermal switch has tripped. Unplug the power or turn off the circuit breaker and allow the appliance to cool down for 15 minutes.
Why does my Napoleon Indoor Fireplace heater shut off?
The heater in your Napoleon Indoor Fireplace might be shutting off because the room is too warm. The heater has a built-in thermostat that causes it to shut off automatically.
What to do if my Napoleon NEFL50B-1 flame does not move?
If the flame in your Napoleon Indoor Fireplace isn’t moving, it could be due to a stalled or malfunctioning motor, or a power failure. Try cycling the appliance on and off. If there was a power failure, re-program the appliance to its original settings (note: this may not be applicable with all appliances).
Why is my Napoleon NEFL50B-1 flame dim or not visible?
A dim or absent flame in your Napoleon Indoor Fireplace can be due to several reasons: * The flame brightness may not be selected properly. Refer to the “operation” section for instructions. * The flame LEDs might be burnt out, requiring inspection and replacement. * The main PCB board could be burnt out, also requiring inspection and possible replacement.
What to do if my Napoleon NEFL50B-1 trips the house circuit breaker?
If your Napoleon Indoor Fireplace trips the house circuit breaker, reset the house circuit breaker.
Why is the ember bed not glowing or is dimming on my Napoleon NEFL50B-1?
If the ember bed in your Napoleon Indoor Fireplace is not glowing or is dimming, it could be due to a few reasons: * The brightness may not be selected. Refer to the “operation” section. * The ember LEDs may be burnt out, requiring inspection and replacement. * The main PCB board may be burnt out, also requiring inspection and replacement.
What to do if my Napoleon NEFL50B-1 Indoor Fireplace appliance’s fuse has blown?
If the fuse in your Napoleon Indoor Fireplace has blown, replace the fuse.
Covers critical safety warnings and precautions for operation and installation.
Specifies required distances from combustible materials for safe appliance installation.
Details the location and operation of the main power switch for the appliance.
Guide to operating the appliance using its remote control and touch display panel.
General| Brand | Napoleon |
|---|---|
| Model | NEFL50B-1 |
| Category | Indoor Fireplace |
| Language | English |
To Next Page