Narwal YJCB012 - Product Introduction and Package; Package Contents

03
Package Contents
Main Units
Accessories
Robot*1
Power cord*1
Side brush*2
Specially Formulated
Floor Cleaner*1
Mopping module*2
Base station*1
Product Introduction
This de
vice contains licence-exempt transmier(s)/receiver that comply with Innovation, Science
and Ec
onomic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
tw
o conditions:1. This device may not cause interference. 2. This device must accept any interference,
inc
luding interference that may cause undesired operation of the device.
W
arning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
CAN ICES-003 (B)/NMB-003(B)
To maintain compliance with the FCC’s RF exposure guidelines, place the product at least 7.9'' from
nearby persons.
Pour rester en conformité avec les consignes d’exposition aux RF, placez le produit à au moins 7.9
''
des personnes proches.
To maintain compliance with the FCC’s RF exposure guidelines, place the product at least 7.9
'' from
nearby persons.
Pour rester en conformité avec les consignes d’exposition aux RF, placez le produit à au moins 7.9
''
des personnes proches.
FCC/IC RF RADIATION EXPOSURE STATEMENT CAUTION:
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception , which can be deter-
mined by turning the equipment o and on, the user is encouraged to try to correct the interference
by one or more of the following measures: Reorient or relocate the receiving antennaIncrease
the separation between the equipment and receiver. Connect the equipment into an outlet on a
circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced
radio/TV technician for help.
The laser distance sensor of this product meets the standards for Class I Laser Products in IEC
60825-1: 2014 and will not generate hazardous laser radiation
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
L' émeeur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'
Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exem
pts de licence. L' exploitation est autorisée aux deux conditions suivantes:
(1)
L' appareil ne doit pas produire de brouillage;
(2)L
' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromere le fonctionnement.